a study on abrasion resistance of concrete

Leave Comment

A STUDY ON ABRASION RESISTANCE OF CONCRETE PAVING

A STUDY ON ABRASION RESISTANCE OF CONCRETE PAVING BLOCKS Aslantaş, Onur M.Sc., Department of Civil Engineering Supervisor: Assistant Prof.Dr. İ. Özgür Yaman December 2004, 93 Pages Concrete block pavement (CBP) can be an alternative pavement to asphalt and concrete pavements. CBP is formed from individual concrete paving blocks (CPBs)

Get price

(PDF) Abrasion Resistance of Concrete – Design ...

This study evaluates concrete resistance of concrete specimens with abrasion in three crack patterns (0°, 45° and 90°), four surface crack widths (0.5, 1, 2 and 3 mm) and two silica fume (5% ...

Get price

Comparative Study of the Abrasion Resistance

Comparative Study of the Abrasion Resistance Of Different Concrete Mixes By Radu Apostoaia, José A. Peña Purdue University Calumet A series of concrete mixes were prepared and tested in the laboratory installations at Purdue University Calumet to determine which mix would show higher resistance to abrasion.

Get price

ABRASION RESISTANCE OF CONCRETE AND THE USE OF

The results of this study shed new light on an old rule of thumb. It is widely believed and supported by many papers in literature that the abrasion resistance of concrete is directly proportional to concrete strength. The current study shows that aggregate hardness plays a

Get price

Abrasion resistance of concrete — Aston Research Explorer

Abstract This thesis describes an experimental study of the abrasion resistance of concrete at both the macro and micro levels. This is preceded by a review related to friction and wear, methods of test for assessing abrasion resistance, and factors influencing the abrasion resistance of concrete.

Get price

Abrasion Resistance of Concrete Design, Construction and ...

crl.issres Vol. 6 (3) – Sept. 2015 Abrasion Resistance of Concrete – Design, Construction and Case Study Benjamin D. Scott1 2and Md. Safiuddin,C 1Structural Designer, Tacoma Engineers ...

Get price

ABRASION RESISTANCE OF CONCRETE AND THE USE OF

The results of this study shed new light on an old rule of thumb. It is widely believed and supported by many papers in literature that the abrasion resistance of concrete is directly proportional to concrete strength. The current study shows that aggregate hardness plays a

Get price

Abrasion Resistance of Ultra-High-Performance Concrete for ...

Jun 14, 2021  abrasion resistance. In another study, Ghafoori and Dia-wara [24] showed increases in abrasion resistance by incorporating up to 10% silica fume in the concrete as a partial replacement of fine aggregate. Later, Ghafoori et al. [25] reported that self-compacting concrete performed better than the conventional vibratory-placed concrete in

Get price

Abrasion resistance of ultra-high performance concrete ...

Jul 12, 2021  Abrasion resistance is a critical property for concrete structures subjected to abrasion deterioration, such as industry floors, pavement, or hydraulic structures. Studies on abrasion resistance of normal concrete have been well established, whereas there is limited research on the abrasion behavior of ultra-high performance concrete (UHPC). This study developed lower-cement UHPC

Get price

Factors Affecting Abrasion Resistance of Concrete Surfaces ...

A laboratory research program on abrasion resistance of concrete which includes the development of an impact type test method to measure this resistance of core specimens, is described. Variables included in this study were slump, finishing, curing, surface treatments (including linseed oil and monomolecular film), and the use of admixtures.

Get price

Concrete Abrasion Resistance: The Bad, the Good, and the ...

Sep 07, 2021  Concrete Abrasion Resistance: The Bad, the Good, and the Better (Interview Part 2) Category. Concrete Best Practices. General. Published on September 7, 2021. In our first part of this interview series, we discussed why concrete abrasion is such an issue for concrete construction and how it’s often treated. (For all the details, give it a read !)

Get price

A simple suggested approach to reduce the testing time of ...

2 天前  This study investigated two types of abrasion resistance of steel–fiber-reinforced concrete in hydraulic structures, friction abrasion and impact abrasion using the ASTM C1138 underwater test ...

Get price

Abrasion and skid resistance of concrete containing waste ...

May 03, 2021  Consequently, in this study, the abrasion resistance, skid properties under wet and dry conditions, and strength properties of concrete mixes comprising waste PP fibers were examined. Concrete mixtures reinforced with PP fibers and using POFA as a partial cement replacement have unique characteristics, and can be used as pavement materials with ...

Get price

Study on frost resistance and abrasion resistance of fiber ...

The frost resistance and abrasion resistance of the fiber mesh reinforced concrete under the simulated treatment of external environment were studied through the frost resistance test and abrasion test. The relative dynamic modulus, the amount of spalling per unit area, the amount of abrasion per unit area and abrasion depth were used as evaluation indexes.

Get price

Compressive Strength and Abrasion Resistance of Concretes ...

crete. There is a dearth of investigation on the resistance of concrete to deep ab-rasion according to BS 6717 [24] now modified as BS EN 1338 . This study [25] therefore reports an experimental study on the abrasion resistance of concrete specimens of varying cement and aggregate contents but fixed water-cement ra-

Get price

Improving the Abrasion Resistance of Concrete to Mitigate ...

abrasion resistance of concrete floors [37]. Horszczaruk reported that steel fiber with an aspect ratio above 50 and polyurethane fiber increased the abrasion resistance of high-performance concrete (HPC) [38]. However, Nanni, Atis et al., and Sonebi and Khayat found that fibers had no effect on the abrasion resistance of concrete [39–41].

Get price

Abrasion resistance and nanoscratch behavior of an ultra ...

As a novel material, ultra-high performance concrete (UHPC) shows the potential to be used as an outstanding wear resistant material whereas there is a lack of detailed research on its abrasion behavior. This study investigated the abrasion resistance of a UHPC as compared with a high performance concrete (HPC), and nanoscratch tests were ...

Get price

Abrasion Resistance of Fiber-Reinforced Concrete under ...

Sep 01, 2020  Abstract: This study aimed to investigate the effect of cold temperatures on the abrasion resistance and mechanical properties of fiber-reinforced concrete mixtures with different saturation conditions. The studied variables included types of steel fibers (SFs) (needle fibers, single hooked ends, and double hooked ends), volumes of SFs (0, 0.35 ...

Get price

Testing Abrasion Resistance of High-Strength Concrete

The Naik et al. (1995) determined the abrasion resistance of Class C study also evaluates the influence of test surface (top, bottom, saw- fly ash concrete proportioned to have five levels of cement re- cut) on the abrasion resistance of HSC. placements (15, 30, 40, 50, and 70%).

Get price

Fine-grained Fiber Concrete on Mechanoactivated Portlandcement

concrete used for flooring in industrial and civil buildings. Characterized by the wellknown advantages (unlimited raw material base, manufacturability, high homogeneity), fine-grained concrete requires an increased consumption of cement to achieve the necessary mechanical characteristics - compressive strength, abrasion, impact resistance.

Get price

Abrasion Resistance of Ultra-High-Performance Concrete for ...

Jun 14, 2021  abrasion resistance. In another study, Ghafoori and Dia-wara [24] showed increases in abrasion resistance by incorporating up to 10% silica fume in the concrete as a partial replacement of fine aggregate. Later, Ghafoori et al. [25] reported that self-compacting concrete performed better than the conventional vibratory-placed concrete in

Get price

Abrasion resistance of concrete — Aston Research Explorer

Abstract This thesis describes an experimental study of the abrasion resistance of concrete at both the macro and micro levels. This is preceded by a review related to friction and wear, methods of test for assessing abrasion resistance, and factors influencing the abrasion resistance of concrete.

Get price

Improving the abrasion resistance of concrete to mitigate ...

Abrasion is a viable mechanism that causes RSD. The objective of this study is to investigate the abrasion resistance of several approaches, such as the addition of mineral admixtures, fibers, and varying curing conditions, to mitigate abrasion of the rail seat.

Get price

Concrete Abrasion Resistance: The Bad, the Good, and the ...

Sep 07, 2021  Concrete Abrasion Resistance: The Bad, the Good, and the Better (Interview Part 2) Category. Concrete Best Practices. General. Published on September 7, 2021. In our first part of this interview series, we discussed why concrete abrasion is such an issue for concrete construction and how it’s often treated. (For all the details, give it a read !)

Get price

Abrasion Resistance of Surface-Treated Concrete - ASTM

The abrasion resistance obtained by the use of penetrating sealer and hardener treatments ranked highest when compared with other air-cured specimen slabs. The application of these treatments reduced the influence of concrete mix design on the abrasion resistance of the slab.

Get price

Study of the effect of consistency on the abrasion ...

Durability of concrete against various aggressive influences, which indicates the lifetime of a construction, is often the main criterion upon designing of up-to-date concretes. These aggressive influences may also include the effect of mechanical wear of a composite caused by abrasion. Recent researches and published studies on this topic are dealing mainly with the effect of input raw ...

Get price

Study on frost resistance and abrasion resistance of fiber ...

The frost resistance and abrasion resistance of the fiber mesh reinforced concrete under the simulated treatment of external environment were studied through the frost resistance test and abrasion test. The relative dynamic modulus, the amount of spalling per unit area, the amount of abrasion per unit area and abrasion depth were used as evaluation indexes.

Get price

A simple suggested approach to reduce the testing time of ...

2 天前  This study investigated two types of abrasion resistance of steel–fiber-reinforced concrete in hydraulic structures, friction abrasion and impact abrasion using the ASTM C1138 underwater test ...

Get price

Testing Abrasion Resistance of High-Strength Concrete

The Naik et al. (1995) determined the abrasion resistance of Class C study also evaluates the influence of test surface (top, bottom, saw- fly ash concrete proportioned to have five levels of cement re- cut) on the abrasion resistance of HSC. placements (15, 30, 40, 50, and 70%).

Get price

Influence of various material parameters on the abrasion ...

Within the scope of the present study, the following conclu- In this investigation, a total of 60 cubes were sions may be drawn. tested as per IS 9284 -1979 procedure to evaluate the abrasion resistance of concrete containing mar- (1) The abrasion resistance of concrete depends ginal aggregates.

Get price

Abrasion-Erosion Resistance of Fiber-Reinforced Concrete

A recent laboratory study on the abrasion-erosion resistance of FRC is presented in this paper. Thirteen concrete mixtures of three watercement ratios ranging from 0.40 to 0.72, each containing one of four different types of steel fibers, were tested.

Get price

Abrasion and Scaling Resistance of Lightweight ... - Concrete

Mar 01, 2021  The study also investigated the abrasion resistance before and after exposure to freezing-and-thawing cycles in the presence of deicing salt. The investigated parameters included different volumes of LC and LF aggregates, three binder contents (500, 550, and 600 kg/m3 [31.2, 34.3, and 37.5 lb/ft3]), and different types of concrete (LWSCC ...

Get price

Standard Test Methods for Determination of Abrasion ...

abrasion resistance of concrete by sand blasting technique. ASTM C 944 test method measures the abrasion resistance of concrete by rotating-cutter machine. ASTM C 779 method evaluates the abrasion resistance of horizontal concrete surface by either revolving disc machine or by ball bearing machine and ASTM C 1138 method

Get price

Abrasion-Resistant Concrete Mix Designs for Precast Bridge ...

I and the Pilot Study to develop HPC mixtures that had improved abrasion resistance and durability characteristics relative to a newly-specified ODOT bridge deck mixture. The mixtures investigated in Phase II incorporated type III portland cement and the same supplementary cementitious materials and natural aggregate that were used in Phase I.

Get price
Contact us

Submit online

Please leave a message below and we will contact you as soon as possible.